Blaine covers about 34 square miles of the Anoka Sand Plain thirteen miles north of downtown Minneapolis, and almost none of it is high ground. The city had 1,700 people in 1950 and more than 20,000 by 1970, and those twenty years built the ramblers and split-entries between Highway 65 and Interstate 35W on the south end of town. The growth since the 1990s went north, into The Lakes, Club West, The Sanctuary, and Wagamon Ranch, where the houses are two-stories and walkouts set among stormwater ponds and the wetlands that were left in place.
Every one of those houses has a full basement dug into wet sand. A 1962 rambler has block walls, a floor drain, and a pit that may have been added in the 1980s. A 2006 two-story has poured walls and drain tile, and its pump runs for weeks every spring.
This site puts Blaine homeowners through by phone to an independent local water damage provider. The provider meters the basement before anything gets written down.
Groundwater through the block or up through the slab during a thaw is a basement flooding cleanup. A pit that overflowed when the pump quit or lost power is a sump pump failure cleanup. A line that split in the rim joist during a January deep freeze is a frozen pipe cleanup. Each one ends with equipment running against daily readings until the walls come back to dry numbers.
Blaine's Public Works crews maintain the city's water system of seventeen deep wells and 200 miles of main serving about 16,000 homes, so a supply-side break in the street is theirs, while the line from the curb stop into the house is yours. On the drain side, the Sewer Division runs 225 miles of sanitary line and thirty lift stations, cleans a third of the system each year, and has an after-hours number for a backup that is coming from the main rather than your own line.
Call (763) 297-2728 and tell us how far the water spread downstairs. An independent local water damage provider serving Blaine takes it from there.
Groundwater or storm runoff pumped out of a Blaine basement, then the carpet pad, paneling, and block walls metered to find what stayed wet.
Cleanup after the pump quit during a snowmelt or lost power in a thunderstorm, and drying of the floor and walls the pit overflow reached.
Standing water pulled off concrete, carpet, and tile on any level of the house, followed by the first moisture readings on the walls.
Air movers and dehumidifiers run against daily readings until the slab, studs, and drywall come back to dry numbers in a closed-up Minnesota house.
Cleanup after a supply line froze in a rim joist, garage wall, or cold corner during a deep freeze and split, then drying of what the thaw soaked.
Wet attic insulation, ceilings, and exterior walls dried after an ice dam at the eave or a storm-torn roof let water into the house.
A tank that let go in the utility room, the water it spread across the basement floor, and the walls it reached pumped out and dried.
Contaminated water that came up a floor drain or basement fixture removed, the porous materials it touched taken out, and the slab cleaned and dried.